Fanuc turret position. But, those parameters are often buried in sub menus.
- Fanuc turret position. 4 of the TURRET SERVO line to 0, then 1. Sounds like to me that if you had to reload the PMC then you probably lost your tool 1 teach position. all you have to do is put the turret to the physical position where tool #1 should be and toggle 1815. We have a Takang TNC-25-S lathe with an old Fanuc 0T. The tool turret is a Duplomatic BSV-N (electronic, not hydraulic) with absolute encoder. It either indexes but is in the wrong position (half way between tools and locks into place), only releases and does not actually turn, or i get a servo alarm on the amplifier. But, those parameters are often buried in sub menus. Jan 8, 2007 ยท It almost always involves getting the turret in correct position and changing a few parameters and then cycling the control power. Since you can rotate your turret then this should be quick and painless. .